Ubiquiti airFiber 5U Guide de l'utilisateur télécharger pdf (Page 6)

LEDs

Signal LEDs

Signal 4 LED will light blue when on.

Signal 3 LED will light green when on.

Signal 2 LED will light yellow when on.

Signal 1 LED will light red when on.

Bootup to airOS When powering on, the Power, GPS, LINK,

and Signal 1-4 LEDs light on. Once the CPU code takes over, the

GPS, LINK, and Signal 1-3 LEDs turn off. Signal 4 LED remains on

to indicate the boot sequence is underway.

Initializing airFiber Software When the airFiber application

begins to boot under airOS, the Signal 4 LED goes from solidly

on to a 2.5 Hz flash. This continues until the AF-5X is fully

booted.

Signal Level Once fully booted, the Signal 1-4 LEDs act as a

bar graph showing how close the AF-5X is to ideal aiming. This

is auto-scaled based on the link range, the antenna gains, and

the configured TX power of the remote AF-5X. Each Signal LED

has three possible states: On, Flashing, and Off. All Signal LEDs

would be solidly on in an ideal link. If the link has a 1 dB loss,

the Signal4 LED will flash; a 2 dB loss and the Signal 4 LED will

turn off. The full bar graph LED states are shown below.

loss

0 -1 -2 -3 -4 -5 -6 -7 -8 -9 -10 -11 -12 -13

1 F 0 0 0 0 0 0 0 0 0 0 0 0

1 1 1 F 0 0 0 0 0 0 0 0 0 0

1 1 1 1 1 F F 0 0 0 0 0 0 0

1 1 1 1 1 1 1 1 1 1 F F F 0

0 = Off, 1 = On, F = Flashing

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Ubiquiti airFiber 5U Guide de l'utilisateur Page 6