Ubiquiti airFiber 5U Guide de l'utilisateur télécharger pdf (Page 24)

b. Loosen the six elevation bolts, and use the hex nut on

the elevation rod to adjust the elevation.

Note: Do NOT make simultaneous adjustments on

the Master and Slave.

2. Slave Visually aim the Slave at the Master. To adjust the

Slave’s position:

a. Loosen the four pole clamp nuts, and rotate the airFiber

antenna on the pole to align the azimuth.

b. Loosen the six elevation bolts, and use the hex nut on

the elevation rod to adjust the elevation.

3. Check to see if a link is established. Ensure that the LINK

LED is solidly lit green and the Signal LEDs of the Slave are

displaying signal levels.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Ubiquiti airFiber 5U Guide de l'utilisateur Page 24